THIN FILM CHIP RESISTORS
61 Series 0.030”x0.030”
All parts are 100% electrically tested, sample tested per MIL-STD-38534 section 3.4, and
visually inspected to MIL-STD-883 requirements. Chips are supplied in standard 2"x 2"
matrix tray packaging.
Ordering Information
Base Part Code
Value (3 digits plus exponent)
Tolerance Letter
61xxx-
NNNE
X
61AC(Nichrome center-tapped)
(Under 100 ohms, an R indicates the
decimal point location)
B=0.1%
C=0.25%
D=0.5%
F=1%
61AL(Nichrome, no center-tap,
values above 500K only)
G=2%
J=5%
K=10%
M=20%
61ACT(Tantalum-nitride center-
tapped)
Ordering examples:
61AC-5002K is a 50 kilohm 10% center-tapped resistor with nichrome metalization.
61AL-1004J is a 1 megohm 5% resistor with nichrome metalization.
61ACT-50R1F is a 50.1 ohm 1% center-tapped resistor with tantalum-nitride metalization
Availability and Limitations:
61AC series is available from 2.5 ohms to 600 kohms
61AL series is available from 250 kohms to 1 megohm
61ACT series is available from 1.25 ohms to 300 kohms
B tolerance is available above 250 ohms
C tolerance is available above 100 ohms
D tolerance is available above 50 ohms
F tolerance is available above 25 ohms
G tolerance is available above 12 ohms
J tolerance is available above 5 ohms
SatCon Electronics also manufactures Custom Substrates on a
variety of materials, a wide range of Microwave, PIN Diode Drivers,
and Custom Hybrid Circuits. Please contact the factory or your local
SatCon Electronics representative for more information.
(Specifications subject to change without notice)
SPECTRUM [ SPECTRUM MICROWAVE, INC. ]
