CY28349B
Table 5. Register Summary (continued)
Name
Description
WD_TO_STATUS
WD_TIMER[4:0]
Watchdog Timer Time-out Status bit
0 = No time-out occurs (READ); Ignore (WRITE)
1 = Time-out occurred (READ); Clear WD_TO_STATUS (WRITE).
These bits store the time-out value of the Watchdog timer. The scale of the timer is determine by the
pre-scaler.
The timer can support a value of 150 ms to 4.8 sec when the prescaler is set to 150 ms. If the prescaler
is set to 2.5 sec, it can support a value from 2.5 sec to 80 sec.
When the Watchdog timer reaches “0”, it will set the WD_TO_STATUS bit.
WD_PRE_SCALER
RST_EN_WD
0 = 150 ms
1 = 2.5 sec
This bit will enable the generation of a Reset pulse when a Watchdog timer time-out occurs.
0 = Disabled
1 = Enabled
RST_EN_FC
This bit will enable the generation of a Reset pulse after a frequency change occurs.
0 = Disabled
1 = Enabled
Program the CPU Output Frequency
“G” stands for the PLL Gear Constant, which is determined by
the programmed value of FS[4:0] or SEL[4:0]. The value is
listed in Table 4.
When the programmable output frequency feature is enabled
(Pro_Freq_EN bit is set), the CPU output frequency is deter-
mined by the following equation:
The ratio of (N+3) and (M+3) need to be greater than “1”
[(N+3)/(M+3) > 1].
Fcpu = G * (N+3)/(M+3).
The following table lists set of N and M values for different
frequency output ranges.This example use a fixed value for
the M-Value Register and select the CPU output frequency by
changing the value of the N-Value Register.
“N” and “M” are the values programmed in Programmable
Frequency Select N-Value Register and M-Value Register,
respectively.
Table 6. Examples of N and M Value for Different CPU Frequency Range
Fixed Value for
Range of N-Value Register
for Different CPU Frequency
Frequency Ranges
50 MHz–129 MHz
130 MHz–248 MHz
Gear Constants
M-Value Register
48.00741
93
45
97–255
48.00741
127–245
Rev 1.0,November 20, 2006
Page 14 of 20
SPECTRALINEAR [ SPECTRALINEAR INC ]
