D a t a S h e e t
START
Read DQ15–DQ0
Addr = VA
Yes
DQ7 = Data?
No
No
DQ5 = 1
Yes
Read DQ15–DQ0
Addr = VA
Yes
DQ7 = Data?
No
PASS
FAIL
Notes:
1. VA = Valid address for programming. During a sector erase operation, a valid
address is any sector address within the sector being erased. During chip erase, a
valid address is any non-protected sector address.
2. DQ7 should be rechecked even if DQ5 = 1 because DQ7 may change simulta-
neously with DQ5.
Figure 5. Data# Polling Algorithm
RY/BY#: Ready/Busy#
The RY/BY# is a dedicated, open-drain output pin which indicates whether an Embedded Al-
gorithm is in progress or complete. The RY/BY# status is valid after the rising edge of the final
WE# pulse in the command sequence. Since RY/BY# is an open-drain output, several RY/BY#
pins can be tied together in parallel with a pull-up resistor to VCC.
If the output is low (Busy), the device is actively erasing or programming. (This includes pro-
gramming in the Erase Suspend mode.) If the output is high (Ready), the device is in the read
mode, the standby mode, or in the erase-suspend-read mode. Table 16 on page 72 shows
the outputs for RY/BY#.
68
S29GL-N MirrorBit™ Flash Family
S29GL-N_00_B3 October 13, 2006