欢迎访问ic37.com |
会员登录 免费注册
发布采购

S29AL016M10BFI020 参数 Datasheet PDF下载

S29AL016M10BFI020图片预览
型号: S29AL016M10BFI020
PDF下载: 下载PDF文件 查看货源
内容描述: 16兆位( 2M ×8位/ IMX 16位), 3.0伏只引导扇区闪存 [16 MEGABIT (2M X 8 BIT / I M X 16 BIT) 3.0 VOLT ONLY BOOT SECTOR FLASH MEMORY]
分类和应用: 闪存内存集成电路
文件页数/大小: 59 页 / 2056 K
品牌: SPANSION [ SPANSION ]
 浏览型号S29AL016M10BFI020的Datasheet PDF文件第25页浏览型号S29AL016M10BFI020的Datasheet PDF文件第26页浏览型号S29AL016M10BFI020的Datasheet PDF文件第27页浏览型号S29AL016M10BFI020的Datasheet PDF文件第28页浏览型号S29AL016M10BFI020的Datasheet PDF文件第30页浏览型号S29AL016M10BFI020的Datasheet PDF文件第31页浏览型号S29AL016M10BFI020的Datasheet PDF文件第32页浏览型号S29AL016M10BFI020的Datasheet PDF文件第33页  
START  
Write Erase  
Command Sequence  
Data Poll  
from System  
Embedded  
Erase  
algorithm  
in progress  
No  
Data = FFh?  
Yes  
Erasure Completed  
Notes:  
1. See Tables 1011 for erase command sequence.  
2. See “DQ3: Sector Erase Timer” for more information.  
Figure 5. Erase Operation  
Program Suspend/Program Resume Command Sequence  
The Program Suspend command allows the system to interrupt a programming  
operation so that data can be read from any non-suspended sector. When the  
Program Suspend command is written during a programming process, the de-  
vice halts the program operation within 15 µs maximum (5 µs typical) and  
updates the status bits. Addresses are not required when writing the Program  
Suspend command.  
After the programming operation has been suspended, the system can read  
array data from any non-suspended sector. The Program Suspend command  
may also be issued during a programming operation while an erase is sus-  
pended. In this case, data may be read from any addresses not in Erase  
Suspend or Program Suspend. If a read is needed from the SecSi Sector area  
(One-time Program area), then user must use the proper command sequences  
to enter and exit this region.  
The system may also write the autoselect command sequence when the device  
is in the Program Suspend mode. The system can read as many autoselect  
codes as required. When the device exits the autoselect mode, the device re-  
verts to the Program Suspend mode, and is ready for another valid operation.  
See Autoselect Command Sequence for more information.  
After the Program Resume command is written, the device reverts to program-  
ming. The system can determine the status of the program operation using the  
April 21, 2004 S29AL016M_00A4  
S29AL016M  
30