CXA2050S
HSIZESW
UP-VLIN
(1)
(4)
: Lowers the E-W OUT DC level (during H-SIZE compression)
0 = Normal
1 = –1.35V
: Vertical linearity adjustment for top of picture (Secondary component gain control for
sawtooth wave added to sawtooth wave AGC output)
0h = 100%
Fh = 115%
(Bottom/top of picture)
(Bottom/top of picture) Top of picture compressed.
LO-VLIN
(4)
(4)
: Vertical linearity adjustment for bottom of picture (Tertiary component gain control
for sawtooth wave added to sawtooth wave AGC output)
0h = 100%
Fh = 75%
(Bottom/top of picture)
(Bottom/top of picture) Bottom of picture compressed.
LEFT-BLK
: HBLK width control for the left side of picture when HBLKSW = 1 (Phase control for
timing pulse generated from HVCO)
0h = +1.7µs
7h = 0µs
HBLK width maximum
Center HBLK: 15µs
Fh = –1.7µs HBLK width minimum
RIGHT-BLK (4)
: HBLK width control for the right side of picture when HBLKSW = 1 (Phase control for
timing pulse generated from HVCO)
0h = +1.7µs
7h = 0µs
HBLK width maximum
Center HBLK: 15µs
Fh = –1.7µs HBLK width minimum
6. Other
AGING
(1)
: White output aging mode ON/OFF switch
(Takes priority over RGB ON and PIC ON control. Set to OFF mode at power-on.)
0 = Aging mode OFF
1 = Aging mode ON (When there is no input signal, a 60 IRE flat signal is output
from the Y block)
– 31 –