SNC21060A
1-CH H.Q. Speech Controller
5.7
I/O Ports
There are three 4-bit I/O ports P1, P2 and P3. Any I/O can be individually
programmed as either input pull low or output. Any valid data transition (H L or
L H) of P1, P2 and P3 can reactivate the chip when it is in power-down stage.
Port
Data
PA
D
Port
Status
Wea
k
To Internal Data Bus
Read Control
I/O Port Configuration
Note:
(1)
Weak N-MOS can serve as pull-low resistor.
(2)
The driving/sink current of P3.3 & P3.2 is up to 8mA/16mA
5.8
IR Function
Bit 3 of Mode Register is applied to control the IR function. P33 can be modulated with
38.5KHz square wave before sent out to P3.3 or P2.3 pin. P3.3 and P2.3 out is
controlled by Mode1.1. If Mode1.1 set 1 IR is use P2.3, set “0” is use P3.3. The IR
signal can be achieved by this modulated signal.
5.9
Watch Dog Timer
SNC21060A built-in an internal WDT (Watch Dog Timer). This Watchdog timer would
issue resets signal to this chip if it is not cleared before reaching terminal count (1sec).
The watchdog timer is enabled at reset and cannot be disabled.
Ver1.1
6
April 28, 2009
SONIX [ SONIX TECHNOLOGY COMPANY ]
