SN8P1700
8-bit micro-controller build-in 12-bit ADC
TC0 INTERRUPT OPERATION
When the TC0C counter occurs overflow, the TC0IRQ will be set to “1” however the TC0IEN is enable or disable. If the
TC0IEN = 1, the trigger event will make the TC0IRQ to be “1” and the system enter interrupt vector. If the TC0IEN = 0,
the trigger event will make the TC0IRQ to be “1” but the system will not enter interrupt vector. Users need to care for
the operation under multi-interrupt situation.
ꢃExample: TC0 interrupt request setup.
B0BCLR
B0BCLR
MOV
B0MOV
MOV
FTC0IEN
FTC0ENB
A, #20H
TC0M, A
A, #74H
TC0C, A
; Disable TC0 interrupt service
; Disable TC0 timer
;
; Set TC0 clock = Fcpu / 64
; Set TC0C initial value = 74H
; Set TC0 interval = 10 ms
B0MOV
B0BSET
B0BCLR
B0BSET
FTC0IEN
FTC0IRQ
FTC0ENB
; Enable TC0 interrupt service
; Clear TC0 interrupt request flag
; Enable TC0 timer
B0BSET
FGIE
; Enable GIE
ꢃExample: TC0 interrupt service routine.
ORG
JMP
8
; Interrupt vector
INT_SERVICE
INT_SERVICE:
B0XCH
PUSH
A, ACCBUF
; B0XCH doesn’ t change C, Z flag
; Push
B0BTS1
JMP
FTC0IRQ
EXIT_INT
; Check TC0IRQ
; TC0IRQ = 0, exit interrupt vector
B0BCLR
FTC0IRQ
; Reset TC0IRQ
MOV
A, #74H
B0MOV
TC0C, A
; Reset TC0C.
.
.
.
.
; TC0 interrupt service routine
EXIT_INT:
POP
; Pop
B0XCH
A, ACCBUF
; Restore ACC value.
RETI
; Exit interrupt vector
SONiX TECHNOLOGY CO., LTD
Page 96
Revision 1.94