16-bit High-Performance Single-Chip 10/100 Ethernet Controller with HP Auto-MDIX
Datasheet
BITS
DESCRIPTION
TYPE
DEFAULT
5-4
WAKE-UP Status (WUPS) – This field indicates the cause of a wake-up
event detection as follows
R/WC
00
00b -- No wake-up event detected
01b -- Energy detected
10b -- Wake-up frame or magic packet detected
11b -- Indicates multiple events occurred
WUPS bits are cleared by writing a ‘1’ to the appropriate bit. The device must
return to the D0 state (READY bit set) before these bits can be cleared.
Note:
In order to clear this bit, it is required that all event sources be
cleared as well. The event sources are described in Figure 3.10,
"PME and PME_INT Signal Generation", on page 38.
3
PME indication (PME_IND). The PME signal can be configured as a pulsed
output or a static signal, which is asserted upon detection of a wake-up
event.
R/W
0b
When set, the PME signal will pulse active for 50mS upon detection of a
wake-up event.
When clear, the PME signal is driven continuously upon detection of a wake-
up event.
The PME signal can be deactivated by clearing the WUPS bits, or by
clearing the appropriate enable (refer to Section 3.9.2.3, "Power
Management Event Indicators," on page 38).
2
PME Polarity (PME_POL). This bit controls the polarity of the PME signal.
When set, the PME output is an active high signal. When reset, it is active
low. When PME is configured as an open-drain output this field is ignored,
and the output is always active low.
R/W
NASR
0b
1
0
PME Enable (PME_EN). When set, this bit enables the external PME signal.
R/W
RO
0b
-
This bit does not affect the PME interrupt (PME_INT).
Device Ready (READY). When set, this bit indicates that LAN9217 is ready
to be accessed. This register can be read when LAN9217 is in any power
management mode. Upon waking from any power management mode,
including power-up, the host processor can interrogate this field as an
indication when LAN9217 has stabilized and is fully alive. Reads and writes
of any other address are invalid until this bit is set.
Note:
With the exception of HW_CFG and PMT_CTRL, read access to
any internal resources is forbidden while the READY bit is cleared.
Revision 1.8 (06-06-07)
88
SMSC LAN9217
DATASHEET
SMSC [ SMSC CORPORATION ]
