欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN9116-MT 参数 Datasheet PDF下载

LAN9116-MT图片预览
型号: LAN9116-MT
PDF下载: 下载PDF文件 查看货源
内容描述: 高效的单芯片10/100非PCI以太网控制器 [Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller]
分类和应用: 控制器PC以太网局域网(LAN)标准
文件页数/大小: 126 页 / 1500 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN9116-MT的Datasheet PDF文件第117页浏览型号LAN9116-MT的Datasheet PDF文件第118页浏览型号LAN9116-MT的Datasheet PDF文件第119页浏览型号LAN9116-MT的Datasheet PDF文件第120页浏览型号LAN9116-MT的Datasheet PDF文件第122页浏览型号LAN9116-MT的Datasheet PDF文件第123页浏览型号LAN9116-MT的Datasheet PDF文件第124页浏览型号LAN9116-MT的Datasheet PDF文件第125页  
Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller  
Datasheet  
Chapter 7 Operational Characteristics  
7.1  
Absolute Maximum Ratings*  
Supply Voltage ...................................................................................................................+3.3V +/- 10%  
Operating Temperature ..........................................................................................................0°C to 70°C  
Storage Temperature.........................................................................................................-65°C to 150°C  
Positive Voltage on any pin, with respect to Ground........................................................................ 5.5V  
Negative Voltage on any pin, with respect to Ground .....................................................................-0.3V  
Note: These maximum ratings do not apply to the following analog pins - ATEST, RBIAS, EXRES1,  
TPO +/-, TPI +/-  
* Stresses exceeding those listed above could cause permanent damage to the device. This is a stress  
rating only and functional operation of the device at any other condition above those indicated in the  
operation sections of this specification is not implied.  
Note: When powering this device from laboratory or system power supplies, it is important that the  
absolute maximum ratings not be exceeded or device failure can result. Some power supplies  
exhibit voltage spikes on their outputs when AC power is switched on or off. In addition, voltage  
transients on the AC power line may appear on the DC output. If this possibility exists, it is  
suggested that a clamp circuit be used.  
7.2  
Power Consumption Device Only  
Power measurements taken under the following conditions:  
Temperature: .................................................................................................................................. +25° C  
Device VDD:..................................................................................................................................+3.30 V  
Table 7.1 Power Consumption Device Only  
MODE  
TOTAL POWER - TYPICAL (MW)  
10BASE-T Operation  
D0, 10BASE-T /w traffic  
D0, Idle  
244  
225  
120  
120  
35  
D1, 10BASE-T /w traffic  
D1, Idle  
D2, Energy Detect Power Down  
D2, General Power Down  
100BASE-TX Operation  
D0, 100BASE-TX /w traffic  
D0, Idle  
11  
422  
367  
262  
D1, 100BASE-T /w traffic  
SMSC LAN9116  
121  
Revision 1.1 (05-17-05)  
DATASHEET