1°C Temperature Sensor with Beta Compensation
Datasheet
Chapter 3 Electrical Specifications
3.1
Absolute Maximum Ratings
Table 3.1 Absolute Maximum Ratings
DESCRIPTION
RATING
UNIT
Supply Voltage (VDD
)
-0.3 to 5.0
-0.3 to 5.5
V
V
Voltage on SMDATA and SMCLK pins
Voltage on any other pin to Ground
Operating Temperature Range
Storage Temperature Range
-0.3 to VDD +0.3
-40 to +125
-55 to +150
V
°C
°C
Lead Temperature Range
Refer to JEDEC Spec. J-STD-
020
Package Thermal Characteristics for MSOP-8
Thermal Resistance (θj-a
)
140.8
2000
°C/W
V
ESD Rating, All pins HBM
Note: Stresses at or above those listed could cause permanent damage to the device. This is a stress
rating only and functional operation of the device at any other condition above those indicated
in the operation sections of this specification is not implied. When powering this device from
laboratory or system power supplies, it is important that the Absolute Maximum Ratings not be
exceeded or device failure can result. Some power supplies exhibit voltage spikes on their
outputs when the AC power is switched on or off. In addition, voltage transients on the AC
power line may appear on the DC output. If this possibility exists, it is suggested that a clamp
circuit be used.
3.2
Electrical Specifications
Table 3.2 Electrical Specifications
VDD = 3.0V to 3.6V, TA = -40°C to 125°C, all typical values at TA = 27°C unless otherwise noted.
CHARACTERISTIC
SYMBOL
MIN
TYP
MAX
UNITS
CONDITIONS
DC Power
Supply Voltage
Supply Current
VDD
IDD
3.0
3.3
3.6
V
150
220
uA
1 conversion / sec, dynamic
averaging disabled
750
uA
> 16 conversions / sec, dynamic
averaging enabled
Revision 1.16 (03-15-07)
SMSC EMC1402
DATA1S0HEET
SMSC [ SMSC CORPORATION ]
