1°C Temperature Sensor with Beta Compensation
Datasheet
4.3
Read Byte
The Read Byte protocol is used to read one byte of data from the registers as shown in Table 4.3.
Table 4.3 Read Byte Protocol
START
SLAVE
ADDRESS
WR
ACK
REGISTER
ADDRESS
ACK
START
SLAVE
ADDRESS
RD
ACK
REGISTER
DATA
NACK
STOP
1 -> 0 1001_100
0
1
XXh
0
1 -> 0 1001_100
1
1
XX
1
0 -> 1
4.4
Send Byte
The Send Byte protocol is used to set the internal address register pointer to the correct address
location. No data is transferred during the Send Byte protocol as shown in Table 4.4.
Table 4.4 Send Byte Protocol
SLAVE
ADDRESS
REGISTER
ADDRESS
START
1 -> 0
WR
ACK
ACK
STOP
1001_100
0
0
XXh
0
0 -> 1
4.5
Receive Byte
The Receive Byte protocol is used to read data from a register when the internal register address
pointer is known to be at the right location (e.g. set via Send Byte). This is used for consecutive reads
of the same register as shown in Table 4.5.
Table 4.5 Receive Byte Protocol
SLAVE
START
ADDRESS
RD
ACK
REGISTER DATA
NACK
STOP
1 -> 0
1001_100
1
0
XXh
1
0 -> 1
4.6
Alert Response Address
The ALERT output can be used as a processor interrupt or as an SMBus Alert.
When it detects that the ALERT pin is asserted, the host will send the Alert Response Address (ARA)
to the general address of 0001_100xb. All devices with active interrupts will respond with their client
address as shown in Table 4.6.
Table 4.6 Alert Response Address Protocol
ALERT
RESPONSE
ADDRESS
DEVICE
ADDRESS
START
RD
ACK
NACK
STOP
1 -> 0
0001_100
1
0
1001_1000
1
0 -> 1
SMSC EMC1402
Revision 2.0 (08-10-12)
DATA1S3HEET
SMSC [ SMSC CORPORATION ]
