Multiple Channel Capacitive Touch Sensor and LED Driver
Datasheet
Table 1.1 Pin Description for CAP1014 (continued)
PIN NUMBER
PIN NAME
PIN FUNCTION
PIN TYPE
23
RESET
Soft reset for system - resets all registers to
default values
DI (5V)
24
N/C
N/C
Not Connected - connect to gnd
Not Connected - connect to gnd
Capacitive Touch Sensor 1
Capacitive Touch Sensor 2
Capacitive Touch Sensor 3
Capacitive Touch Sensor 4
Capacitive Touch Sensor 5
Capacitive Touch Sensor 6
Capacitive Touch Sensor 7
Power Ground
N/A
N/A
25
26
CS1
CS2
CS3
CS4
CS5
CS6
CS7
GND
AIO
AIO
AIO
AIO
AIO
AIO
AIO
Power
27
28
29
30
31
32
Bottom Plate
The pin types are described in detail below. All pins labelled with (5V) are 5V tolerant.
Note: For all 5V tolerant pins that require a pull-up resistor, the voltage difference between VDD and
the pull-up voltage must never exceed 3.6V.
Table 1.2 Pin Types
PIN TYPE
DESCRIPTION
Power
DI
This pin is used to supply power or ground to the device.
Digital Input - this pin is used as a digital input. This pin is 5V tolerant.
Digital Input Output - this pin is used as a digital input / output.
Analog Input / Output - this pin is used as an I/O for analog signals.
DIO
AIO
DIOD
Digital Input / Open Drain Output - this pin is used as an digital I/O. When it is used as an
output, It is open drain and requires a pull-up resistor. This pin is 5V tolerant.
OD
DO
Open Drain Digital Output - this pin is used as a digital output. It is open drain and requires
a pull-up resistor. This pin is 5V tolerant.
Push-pull Digital Output - this pin is used as a digital output and can sink and source current
SMSC CAP1014
11
Revision 1.65 (08-11-09)
DATASHEET