ST7669V
9.1.29 TEON: Tearing Effect Line On (35H)
A0
0
RD
1
WR
0
D7
0
D6
0
D5
1
D4
1
D3
0
D2
1
D1
0
D0
1
HEX
35H
-
Command
1st parameter
1
1
0
-
-
-
-
-
-
-
M
NOTE: “-“ Don’t care
Description This command is used to turn ON the Tearing Effect output signal from the TE signal line. This output is
not affected by changing MADCTL bit ML.
The Tearing Effect Line On has one parameter, which describes the mode of the Tearing Effect
Output Line. (“-“=Don’t Care).
When M=0:
The Tearing Effect Output signal consists of V-Sync(tVDH) information.
When M=1:
The Tearing Effect Output signal consists of both H-Sync(tHDH) and V-Sync(tVDH) information.
Note: During Sleep In Mode with Tearing Effect Line On, Tearing Effect Output pin will be active Low.
Restriction This command has no effect when Tearing Effect output is already ON.
Register
Availability
Status
Availability
Yes
Normal Mode On, Idle Mode Off, Sleep Out
Normal Mode On, Idle Mode On, Sleep Out
Partial Mode On, Idle Mode Off, Sleep Out
Partial Mode On, Idle Mode On, Sleep Out
Sleep In
Yes
Yes
Yes
Yes
Default
Status
Power On Sequence
S/W Reset
Default Value
Tearing effect off & M=0
Tearing effect off & M=0
Tearing effect off & M=0
H/W Reset
Ver 1.3
119/208
6/4/2008
SITRONIX [ SITRONIX TECHNOLOGY CO., LTD. ]
