®
SP322
Programmable V.11/V.35Transceiver
■ +5V Only Operation
■ Programmable V.11 or V.35 Selection
■ Three Differential V.11 Transceivers in
V.11 Mode
■ Three Differential V.35 Transceivers in
V.35 Mode
■ No External Resistor Termination for
Compliant V.35 Operation
■ V.11 Cable Termination (approx. 120Ω)
Internally Configured in V.11 Mode
■ Tri-State capability on drivers and
receivers
■ Ideal low cost solution for X.25 or Frame
Relay Serial Ports
DESCRIPTION
The SP322 is a programmable V.11 or V.35 transceiver IC. The SP322 contains three drivers
and three receivers when selected in each mode. The selection is done by the V.11/V.35 select
pin. The V.11 transceivers can typically operate at 10Mbps while adhering to the ITU V.11
specifications. The V.35 transceivers can operate up to 10Mbps while adhering to the ITU V.35
specifications.
TheSP322 containsinternalresistorterminationforcompliantV.35operationaswellastheV.11
termination on the receiver inputs for optional cable termination. Each SP322 driver contains a
control pin which disables the output and places the output pins in a high impedance state. Each
receiver also has a control pin which places the receiver outputs in a high impedance state. The
enable pins will disconnect the internal termination network for whichever mode the SP322 is
selected. For the receivers, the enable pin will place the input pins in a high impedance (approx.
15kΩ). This allows for convenient DTE-DCE configuration by connecting the driver outputs to
the receiver inputs, thus allowing the enable pins to select the desired DTE or DCE operation.
V.35
WAN
EIA-530
SP322DS/06
Rev. 7/9/03
SP322 V.11/V.35 Serial Transceiver
SP322 V.11/V.35 Serial Transceiver
© Copyright 1997 Sipex Corporation
© Copyright 2003 Sipex Corporation
1
SIPEX [ SIPEX CORPORATION ]
