Si1000/1/2/3/4/5
25.1. Enhanced Baud Rate Generation
The UART0 baud rate is generated by Timer 1 in 8-bit auto-reload mode. The TX clock is generated by
TL1; the RX clock is generated by a copy of TL1 (shown as RX Timer in Figure 25.2), which is not user-
accessible. Both TX and RX Timer overflows are divided by two to generate the TX and RX baud rates.
The RX Timer runs when Timer 1 is enabled, and uses the same reload value (TH1). However, an
RX Timer reload is forced when a START condition is detected on the RX pin. This allows a receive to
begin any time a START is detected, independent of the TX Timer state.
Timer 1
TL1
UART
Overflow
TX Clock
2
2
TH1
Start
Detected
Overflow
RX Clock
RX Timer
Figure 25.2. UART0 Baud Rate Logic
Timer 1 should be configured for Mode 2, 8-bit auto-reload (see Section “27.1.3. Mode 2: 8-bit Coun-
ter/Timer with Auto-Reload” on page 333). The Timer 1 reload value should be set so that overflows will
occur at two times the desired UART baud rate frequency. Note that Timer 1 may be clocked by one of six
sources: SYSCLK, SYSCLK / 4, SYSCLK / 12, SYSCLK / 48, the external oscillator clock / 8, or an exter-
nal input T1. For any given Timer 1 clock source, the UART0 baud rate is determined by Equation 25.1-A
and Equation 25.1-B.
1
2
A)
B)
--
UartBaudRate = T1_Overflow_Rate
T1CLK
T1_Overflow_Rate = -------------------------
256 – TH1
Equation 25.1. UART0 Baud Rate
Where T1
is the frequency of the clock supplied to Timer 1, and T1H is the high byte of Timer 1 (reload
CLK
value). Timer 1 clock frequency is selected as described in Section “27.1. Timer 0 and Timer 1” on
page 332. A quick reference for typical baud rates and system clock frequencies is given in Table 25.1
through Table 25.2. Note that the internal oscillator may still generate the system clock when the external
oscillator is driving Timer 1.
25.2. Operational Modes
UART0 provides standard asynchronous, full duplex communication. The UART mode (8-bit or 9-bit) is
selected by the S0MODE bit (SCON0.7). Typical UART connection options are shown below.
Rev. 1.0
311