Si1000/1/2/3/4/5
Table 24.1. SMBus Clock Source Selection
SMBCS1 SMBCS0 SMBus Clock Source
0
0
1
1
0
1
0
1
Timer 0 Overflow
Timer 1 Overflow
Timer 2 High Byte Overflow
Timer 2 Low Byte Overflow
The SMBCS1–0 bits select the SMBus clock source, which is used only when operating as a master or
when the Free Timeout detection is enabled. When operating as a master, overflows from the selected
source determine the absolute minimum SCL low and high times as defined in Equation 24.1. Note that the
selected clock source may be shared by other peripherals so long as the timer is left running at all times.
For example, Timer 1 overflows may generate the SMBus and UART baud rates simultaneously. Timer
configuration is covered in Section “27. Timers” on page 330.
1
THighMin = TLowMin = ---------------------------------------------
fClockSourceOverflow
Equation 24.1. Minimum SCL High and Low Times
The selected clock source should be configured to establish the minimum SCL High and Low times as per
Equation 24.1. When the interface is operating as a master (and SCL is not driven or extended by any
other devices on the bus), the typical SMBus bit rate is approximated by Equation 24.2.
fClockSourceOverflow
BitRate = ---------------------------------------------
3
Equation 24.2. Typical SMBus Bit Rate
Figure 24.4 shows the typical SCL generation described by Equation 24.2. Notice that T
is typically
HIGH
twice as large as T
. The actual SCL output may vary due to other devices on the bus (SCL may be
LOW
extended low by slower slave devices, or driven low by contending master devices). The bit rate when
operating as a master will never exceed the limits defined by equation Equation 24.1.
Timer Source
Overflows
SCL
TLow
THigh
SCL High Timeout
Figure 24.4. Typical SMBus SCL Generation
Setting the EXTHOLD bit extends the minimum setup and hold times for the SDA line. The minimum SDA
setup time defines the absolute minimum time that SDA is stable before SCL transitions from low-to-high.
The minimum SDA hold time defines the absolute minimum time that the current SDA value remains stable
after SCL transitions from high-to-low. EXTHOLD should be set so that the minimum setup and hold times
meet the SMBus Specification requirements of 250 ns and 300 ns, respectively. Table 24.2 shows the min-
Rev. 1.0
291