C8051F336/7/8/9
25.3.4. Frequency Output Mode
Frequency Output Mode produces a programmable-frequency square wave on the module’s associated
CEXn pin. The capture/compare module high byte holds the number of PCA clocks to count before the out-
put is toggled. The frequency of the square wave is then defined by Equation 25.1.
FPCA
----------------------------------------
=
FCEXn
2 × PCA0CPHn
Note: A value of 0x00 in the PCA0CPHn register is equal to 256 for this equation.
Equation 25.1. Square Wave Frequency Output
Where F
is the frequency of the clock selected by the CPS2–0 bits in the PCA mode register,
PCA
PCA0MD. The lower byte of the capture/compare module is compared to the PCA counter low byte; on a
match, CEXn is toggled and the offset held in the high byte is added to the matched value in PCA0CPLn.
Frequency Output Mode is enabled by setting the ECOMn, TOGn, and PWMn bits in the PCA0CPMn reg-
ister. Note that the MATn bit should normally be set to ‘0’ in this mode. If the MATn bit is set to ‘1’, the CCFn
flag for the channel will be set when the 16-bit PCA0 counter and the 16-bit capture/compare register for
the channel are equal.
Write to
0
PCA0CPLn
ENB
Reset
PCA0CPMn
P E C C M T P E
W C A A A O W C
M O P P T G M C
1 M P N n n n F
Write to
PCA0CPHn
ENB
PCA0CPLn
8-bit Adder
PCA0CPHn
1
Adder
Enable
6 n n n
n
n
TOGn
x
0 0 0
x
Toggle
0
CEXn
8-bit
Comparator
match
Enable
Crossbar
Port I/O
1
PCA Timebase
PCA0L
Figure 25.7. PCA Frequency Output Mode
216
Rev. 0.2