Installation
Installation in front panels
Step
Action
1
Working from the front, insert the operating unit in the mounting cut-out provided.
Make sure the unit cannot drop out of the front panel before it has been secured.
2
Insert the hooks of the screw-type clamps enclosed in the corresponding
recesses in the housing of the operating unit.
The individual positions are indicated in the figure by means of arrows.
Front panel
Operating unit
3
Use a screwdriver to tighten the operating unit from the rear in the front panel.
Note
S
S
Make sure the seal is seated correctly against the front panel.
Never apply torques greater than 0.5 Nm in order to prevent damage.
TP070 Equipment Manual
Release03/00
8-3
SIEMENS [ Siemens Semiconductor Group ]
