SAW FILTER
HD F4522
The specimen shall be passed through the reflow
furnace with the condition shown in the above
profile for 1 time.
The specimen shall be stored at standard
atmospheric conditions for 1h, after which the
measurement shall be made. Test board shall be
1.6 mm thick. Base material shall be glass fabric
base epoxy resin.
Solder ability Immerse the pins melt solder at 260℃+5/-0℃ More then 95% of
for 5 sec.
total area of the
pins should be
covered with solder
6.Mechanical Test
Items
Conditions
Specifications
Vibration
600-3300rpm amplitude 1.5mm
3 directions 2 H each
There shall be no
damage.
Drop
Lead pull
Lead bend
On maple plate from 1m high 3 times
Pull with 1kg force for 30 seconds
90o bending with 500g weigh 2 times
7. REMARK
7.1 Static voltage
Static voltage between signal load & ground may cause deterioration &destruction of
the component. Please avoid static voltage.
7.2 Ultrasonic cleaning
Ultrasonic vibration may cause deterioration & destruction of the
Please avoid ultrasonic cleaning
component.
7.3 Soldering
Only leads of component may be soldered. Please avoid soldering another part of
component.
www.shoulder.cn Tel:0755-82916880 Fax:0755-82916881 E-mail:info@shoulder.cn
Page 9 of 12
SHOULDER [ SHOULDER ELECTRONICS LIMITED. ]
