PC8171xNSZ1B Series
● Cleaning instructions
Solvent cleaning :
Solvent temperature should be 45˚C or below. Immersion time should be 3 minutes or less.
Ultrasonic cleaning :
The impact on the device varies depending on the size of the cleaning bath, ultrasonic output, cleaning time,
size of PCB and mounting method of the device.
Therefore, please make sure the device withstands the ultrasonic cleaning in actual conditions in advance of
mass production.
Recommended solvent materials :
Ethyl alcohol, Methyl alcohol and Isopropyl alcohol.
In case the other type of solvent materials are intended to be used, please make sure they work fine in ac-
tual using conditions since some materials may erode the packaging resin.
● Presence of ODC
This product shall not contain the following materials.
And they are not used in the production process for this product.
Regulation substances : CFCs, Halon, Carbon tetrachloride, 1.1.1-Trichloroethane (Methylchloroform)
Specific brominated flame retardants such as the PBB and PBDE are not used in this product at all.
(1) The RoHS directive(2011/65/EU)
This product complies with the RoHS directive(2011/65/EU)
Object substances: mercury, lead, cadmium, hexavalent chromium, polybrominated biphenyls
（PBB）and polybrominated diphenyl ethers（PBDE）
(2) Content of six substances specified in Management Methods for Control of Pollution Caused
by Electronic Information Products Regulation (Chinese : 电子信息产品污染控制管理办法).
Marking Styles for the Names and Contents of the Hazardous Substances
Hazardous Substances
Category
Photocoupler
Lead
Mercury
Cadmium
(Pb)
(Hg)
○
(Cd)
Hexavalent
chromium
Polybrominated
biphenyls
Polybrominated
diphenyl ethers
(Cr
6+
)
○
○
○
(PBB)
○
(PBDE)
○
This table is prepared in accordance with the provisions of SJ/T 11364.
○：Indicates that said hazardous substance contained in all of the homogeneous materials
for this part is below the limit requirement of GB/T 26572.
Sheet No.: OP18004EN
11
SHARP [ SHARP ELECTRIONIC COMPONENTS ]
