9. Soldering Profile
1) Recommended Wave Soldering Conditions / Profile
• Preliminary heating to be at 85ºC(120 ºC max) for 20 seconds(60 seconds max).
• Soldering heat to be at 255 ºC (260ºC max) for 4 seconds (5 seconds max.)
• Soak time above 200 ºC is 5 seconds
3 0 0
PEAK
2 5 0
4s (5s max)
255 ºC (260 ºC max)
2 0 0
1 5 0
1 0 0
5 0
PREHEAT
20s (60s Max)
85 ºC(120 ºC max)
0
0
2
4
6
8
1 0 1 2 1 4 1 6 1 8 2 0 2 2 2 4 2 6 2 8 3 0 3 2 3 4 3 6
T im e [s ]
2) Hand Soldering conditions
• Not more than 3 seconds at max. 350ºC, under Soldering iron.
3) Caution
• Lead frames are silver plated copper alloy. This substance has a low thermal coefficient
(easily conducts heat)
• No closer than 1.5mm from the base of the stopper.
• The LEDs must not be repositioned after soldering.
• Do not apply any stress to the lead particularly when heat.
Note : In case the soldered products are reused in soldering process, we don’t guarantee the products.
Rev. 00
December 2007
www.ZLED.com
Document No. : SSC-QP-7-07-24 (Rev.00)
<080407> Rev. 1.6
SEOUL [ Seoul Semiconductor ]
