Handling of Silicone resin LEDs
Z-Power LED is encapsulated by silicone resin for the highest flux efficiency.
Notes for handling of Silicone resin Z-Power LEDs
• Avoid touching silicone resin parts especially by sharp tools such as Tweezers
• Avoid leaving fingerprints on silicone resin parts.
• Please store the LEDs away from dusty areas or seal the product against dust.
• When populating boards in SMT production, there are basically no restrictions
regarding the form of the pick and place nozzle, except that mechanical pressure on
the surface of the resin must be prevented.
• Please do not use a force of over 3000 gf impact or pressure diagonally on the silicon
lens. This may cause a catastrophic failure.
• Please do not mold over the silicone lens with another resin.
(epoxy, urethane, etc)
31
Rev 06 – 2007 / 08
www.zled.com