500mA CMOS LDO Voltage Regulator
(Preliminary)
Note 1:
Exceeding the absolute maximum rating may damage the device.
Note 2:
The device is not guaranteed to function outside its operating rating.
SE5218
Note 3:
The maximum allowable power dissipation at any T
A
(ambient temperature) is calculated using: P
D(MAX)
=
(T
J(MAX)
– T
A
)/Θ
JA
.
Exceeding the maximum allowable power dissipation will result in excessive die temperature, and
See “Thermal Consideration” section for details
the regulator will go into thermal shutdown.
Note 4:
Output voltage temperature coefficient is the worst case voltage change divided by the total temperature range.
Note 5:
Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested
for load regulation in the load range from 10mA to 500mA. Changes in output voltage due to heating effects are
covered by the thermal regulation specification.
Note 6:
Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its
nominal value measured at 1V differential.
Note 7:
The Cin or Cout should be chosen carefully. Please refer to the Application Hints
Block Diagram
Revision
12/5/2008
Preliminary and all contents are subject to change without prior notice.
© Seaward Electronics, Inc., 2005. • www.seawardinc.com.cn • Page 4