Application Hints
Like any low dropout regulator, SE5169 requires
external capacitors to ensure stability.
ensure performance.
The
external capacitors must be carefully selected to
Thermal Considerations
It is important that the thermal limit of the package is
not exceeded.
protection.
to ground.
The SE5169 has built-in thermal
When the thermal limit is exceeded,
The power dissipation for a given
the IC will enter protection, and V
OUT
will be pulled
application can be calculated as following:
The power dissipation (P
D
) is
P
D
= I
OUT
* [V
IN
– V
OUT
]
The thermal limit of the package is then limited to
P
D(MAX)
= [T
J
– T
A
]/Θ
JA
where T
J
is the junction
temperature, TA is the ambient temperature, and
Θ
JA
is around 250°C/W for SE5169.
SE5169 is
designed to enter thermal protection at 150°C. For
example, if T
A
is 25°C then the maximum P
D
is
limited to about 0.5W. In other words, if I
OUT(MAX)
=
300mA, then [V
IN
– V
OUT
] cannot exceed 1.67V.
Input Capacitor
An input capacitor of at least 1μF is required.
Ceramic or Tantalum can be used. The value can
be increase without upper limit.
Output Capacitor
An output capacitor is required for stability. It must
be placed no more than 1 cm away from the V
OUT
pin, and connected directly between V
OUT
and GND
pins.
The minimum value is 1μF but may be
increase without limit.
Revision
12/4/2008
Preliminary and all contents are subject to change without prior notice
© Seaward Electronics Inc., 2006. • www.seawardinc.com.cn • Page 6
SEAWARD [ Seaward Electronics Inc. ]
