PM2002DP
ssaammeess
COMPONENT LISTS
The following component list covers all components fitted on the PM2002DP module as shipped
Symbol
Description
Detail
DIP-20
U1
SA2002D
D1, D2
D3, D4
R1, R3
R2, R15
R4, R5
R6, R7
R8, R9
R10
Diode, Silicon, 1N4007
Diode, Zener, 2.4V
Resistor, 47k, 1/4W, 1%, metal
Resistor, 150k, 1/4W, 1%, metal
Resistor, 100R, 1/4W, 1%, metal
Resistor, 1.6k, 1/4W, 1%, metal
Resistor, 2.4k, 1/4W, 1%, metal
Resistor, 47R, 2W, 5%, wire wound
Resistor, 22k, 1/4W, 1%, metal
Resistor, 1M, 1/4W, 1%, metal
Resistor, 24k, 1/4W, 1%, metal
Shunt resistor, 80A / 50mV
Resistor, 1/4W, 1%, metal
Resistor, 1/4W, 1%, metal
Note 1
R11
R12
R13
R14
R16
Note 1
P1
C1, C2
C3, C4
C5
Capacitor, 220nF
Capacitor, 220nF, 16V, electrolytic
Capacitor, 470nF, 250VAC
Capacitor, 820nF
Capacitor
C6
Note 2
C7
C8
Capacitor, 2200uF, 16V, electrolytic
3mm Light emitting diode
LED1, LED2
CNT1
SCK1
JP3
Impulse counter, Kuebler, K07.80
Molex 3 pin connector, 200mil pin spacing
Molex 2 pin connector, 100mil pin spacing
6
Jumpers
24
Header pins
Note1: In case a current transformer is used on the board R16 is the termination resistor. Resistors R6 and R7 values may need to be
changed to match the CT used.
Note2:Capacitor values may be selected to compensate for phase errors caused by current transformers.
Table 4: Components for PM200DP module set up for 220V/80A
5/10
http://www.sames.co.za