VS85VLNVWM
Data sheet
●Appended figure
Procedure to obtain ESD Clampimg Voltage
IEC61000-4-2 Spec
IEC61000-4-2 Waveform
C :150pFꢀR :330Ω
S
d
simplified diagram in ESD machine
1Set up ESD Tester at IEC61000-4-2 condition.
(IEC61000-4-2 :C=150pF, R=330Ω)
2Mount a sample on the high frequency test board
with the SMAconnector.
3Connect the SMAconnector to the oscilloscope
by 50Ωcable.
Then, add the 10X-attenuator between test board
and the cable to protect the oscilloscope.
4Discharge ESD in contact discharge mode at any voltage.
(normally 8kV Max.)
www.rohm.com
©2022- ROHMCo., Ltd.All rights reserved.
6/7
2022/02/08_Rev.001