P re c is io n , Hig h -S id e
Cu rre n t -S e n s e Am p lifie rs
R
SENSE
RS+
RS+
RS-
RS-
TO LOAD/CHARGER
POWER
SOURCE
OR
3V
TO
36V
MAX471
GND
SIGN
OUT
LOGIC
SUPPLY
RG2
RG1
BATTERY
LOGIC
SUPPLY
TO LOAD/
CHARGER
100k
3V
TO
36V
100k
MAX472
OUT
1
8
7
6
5
SHDN
N.C.
RS+
RS+
RS-
RS-
V
CC
2
3
4
R
OUT
RG2
RG1
MAX471
GND
SIGN
OUT
SIGN
GND
1/MAX472
V
OUT
1k
Figure 3. Paralleling MAX471s to Sense Higher Load Current
Figure 4. MAX472 Standard Application Circuit
for c urre nt s umming . A s ing le s c a ling re s is tor is
required when summing OUT currents from multiple
devices (Figure 3). Current can be integrated by con-
necting OUT to a capacitive load.
S h u t d o w n
When SHDN is high, the MAX471/MAX472 are shut
down and consume less than 18µA. In shutdown mode,
SIGN is high impedance and OUT turns off.
S IGN Ou t p u t
The current at OUT indicates magnitude. The SIGN out-
put indicates the current’s direction. Operation of the
SIGN comparator is straightforward. When Q1 (Figures
1 and 2) conducts, the output of A1 is high while A2’s
output is zero. Under this condition, a high SIGN output
indicates positive current flow (from RS+ to RS-). In bat-
tery-operated systems, this is useful for determining
whether the battery is charging or discharging. The
SIGN output may not correctly indicate if the load cur-
__________Ap p lic a t io n s In fo rm a t io n
MAX4 7 1
The MAX471 obtains its power from the RS- pin. This
includes MAX471 current consumption in the total sys-
tem current measured by the MAX471. The small drop
across R
mance.
does not affect the MAX471’s perfor-
SENSE
Resistor Selection
Since OUT delivers a current, an external voltage gain-
rent is such that I
is less than 3.5µA. The MAX471’s
OUT
setting resistor (R to ground) is required at the OUT
OUT
SIGN output accurately indicates the direction of cur-
rent flow for load currents greater than 7mA.
pin in order to get a voltage. R
is internal to the
SENSE
MAX471. RG1 and RG2 are factory trimmed for an out-
put current ratio (output current to load current) of
500µA/A. Since they are manufactured of the same
material and in very close proximity on the chip, they
provide a high degree of temperature stability. Choose
SIGN is an open-collector output (sinks current only),
allowing easy interface with logic circuits powered from
any voltage. Connect a 100kΩ pull-up resistor from
SIGN to the logic supply. The convention chosen for
the polarity of the SIGN output ensures that it draws no
current when the battery is being discharged. If current
direction is not needed, float the SIGN pin.
R
for the desired full-scale output voltage up to RS-
OUT
- 1.5V (see the Current Output section).
8
_______________________________________________________________________________________
ROCHESTER [ Rochester Electronics ]
