欢迎访问ic37.com |
会员登录 免费注册
发布采购

RT7262E 参数 Datasheet PDF下载

RT7262E图片预览
型号: RT7262E
PDF下载: 下载PDF文件 查看货源
内容描述: 2A , 21V 500kHz的同步降压型转换器 [2A, 21V 500kHz Synchronous Step-Down Converter]
分类和应用: 转换器TI的电源Demo板
文件页数/大小: 17 页 / 380 K
品牌: RICHTEK [ RICHTEK TECHNOLOGY CORPORATION ]
 浏览型号RT7262E的Datasheet PDF文件第1页浏览型号RT7262E的Datasheet PDF文件第2页浏览型号RT7262E的Datasheet PDF文件第3页浏览型号RT7262E的Datasheet PDF文件第5页浏览型号RT7262E的Datasheet PDF文件第6页浏览型号RT7262E的Datasheet PDF文件第7页浏览型号RT7262E的Datasheet PDF文件第8页浏览型号RT7262E的Datasheet PDF文件第9页  
RT7262E
Operation
The RT7262E is a constant frequency, current mode
synchronous step-down converter. In normal operation,
the high side N-MOSFET is turned on when the S-R latch
is set by the oscillator and is turned off when the current
comparator resets the S-R latch. While the high side N-
MOSFET is turned off, the low side N-MOSFET is turned
on to conduct the inductor current until next cycle begins.
Error Amplifier
The error amplifier adjusts its output voltage by comparing
the feedback signal (V
FB
) with the internal reference. When
the load current increases, it causes a drop in the feedback
voltage relative to the reference. The error amplifier's output
voltage then rises to allow higher inductor current to match
the load current.
Oscillator
The internal oscillator runs at fixed frequency 500kHz. In
short circuit condition, the frequency is reduced to 150kHz
for low power consumption.
Internal Regulator
The regulator provides low voltage power to supply the
internal control circuits and the bootstrap power for high
side gate driver.
Enable
The converter is turned on when the EN pin is higher than
2V. When the EN pin is lower than 0.4V, the converter will
enter shutdown mode and reduce the supply current to
be less than 1μA.
Soft-Start (SS)
An internal current source charges an internal capacitor
to build a soft-start ramp voltage. The FB voltage will track
the internal ramp voltage during soft-start interval. The
typical soft-start time is 4ms.
UV Comparator
If the feedback voltage (V
FB
) is lower than 0.4V, the UV
Comparator will go high to turn off the high side MOSFET.
The output under voltage protection is designed to operate
in Hiccup mode. When the UV condition is removed, the
converter will resume switching.
Thermal Shutdown
The over temperature protection function will shut down
the switching operation when the junction temperature
exceeds 150°C. Once the junction temperature cools
down by approximately 30°C, the converter will
automatically resume switching.
Copyright
©
2012 Richtek Technology Corporation. All rights reserved.
is a registered trademark of Richtek Technology Corporation.
www.richtek.com
4
DS7262E-00
November 2012