欢迎访问ic37.com |
会员登录 免费注册
发布采购

RT5712E 参数 Datasheet PDF下载

RT5712E图片预览
型号: RT5712E
PDF下载: 下载PDF文件 查看货源
内容描述: [暂无描述]
分类和应用:
文件页数/大小: 14 页 / 929 K
品牌: RICHTEK [ RICHTEK TECHNOLOGY CORPORATION ]
 浏览型号RT5712E的Datasheet PDF文件第1页浏览型号RT5712E的Datasheet PDF文件第3页浏览型号RT5712E的Datasheet PDF文件第4页浏览型号RT5712E的Datasheet PDF文件第5页浏览型号RT5712E的Datasheet PDF文件第6页浏览型号RT5712E的Datasheet PDF文件第7页浏览型号RT5712E的Datasheet PDF文件第8页浏览型号RT5712E的Datasheet PDF文件第9页  
RT5712E
Functional Pin Description
Pin No.
1
2
3
4
Pin Name
PGOOD
EN
VIN
LX
Pin Function
Power good indicator. The output of this pin is an open-drain with external
pull-up resistor. PGOOD is pulled up when the FB voltage is within 90%,
otherwise it is LOW.
Enable control input.
Supply voltage input. The RT5712E operates from a 2.7V to 6V input.
Switch node.
Ground. The exposed pad must be soldered to a large PCB and connected to
GND for maximum thermal dissipation.
Feedback.
5, 7 (Exposed Pad) GND
6
FB
Functional Block Diagram
EN
VIN
UVLO
OTP
Shut Down
Control
Error
Amplifier
R
C
C
COMP
+
-
Ton
Comparator
+
-
LX
VIN
FB
V
REF
-
+
Logic
Control
Current
Limit
Detector
Current
Sense
Driver
LX
GND
LX
PGOOD
Operation
The RT5712E is a synchronous low voltage step-down
converter that can support the input voltage range from
2.7V to 6V and the output current can be up to 2A. The
RT5712E uses a constant on-time, current mode
architecture. In normal operation, the high side
P-MOSFET is turned on when the switch controller is
set by the comparator and is turned off when the Ton
comparator resets the switch controller.
Low side MOSFET peak current is measured by
internal RSENSE. The error amplifier EA adjusts
COMP voltage by comparing the feedback signal (V
FB
)
from the output voltage with the internal 0.6V reference.
When the load current increases, it causes a drop in
the feedback voltage relative to the reference, then the
COMP voltage rises to allow higher inductor current to
match the load current.
Copyright © 2019 Richtek Technology Corporation. All rights reserved.
UV Comparator
If the feedback voltage (V
FB
) is lower than threshold
voltage 0.2V, the UV comparator's output will go high
and the switch controller will turn off the high side
MOSFET. The output under voltage protection is
designed to operate in Hiccup and Latch-off mode.
PGOOD Comparator
When the feedback voltage (V
FB
) is higher than
threshold voltage 0.54V, the PGOOD open drain output
will be high impedance. The internal PGOOD MOSFET
is typical 100. The PGOOD signal delay time from EN
is about 2ms.
is a registered trademark of Richtek Technology Corporation.
www.richtek.com
2
DS5712E-03
June 2019