RT5090C
Pin No.
Pin Name
Pin Function
BUCK1 enable and current limit setting (CS) input. Connect a resistor to
GND to set the threshold for BUCK1 synchronous R
DS(ON)
sense. The GND
to PHASE1 current limit threshold is 1/12th the voltage seen at CS over a
0.515V to 3V range. Leave CS floating or drive it above 4.5V to shutdown
BUCK1.
Voltage detection for depop function. Connect to Input Power or Standby
Power Ratio Voltage.
Device Power Supply. Internal LDO Supply from VIN1 or External Power
Supply. With 4.7F MLCC to AGND, as close as possible to VCC pin.
Analog ground.
Connect to capacitor. Hold up capacitors to keep enough energy to supply
control logic when remove input power for depop function.
Enable control. The power on of rails when this pin be pulled high, vice
versa.
The rails alive or turn-off in sleep mode (DC OFF) can by register 0x08
setting.
Reset signal for SOC.
Clock input for the I
2
C interface.
Data line for the I
2
C interface.
Power input for LDO. Input Capacitors as close as possible to VIN_LDO pin.
Power ground. Connect to GND.
31
ENTRIP
32
33
34
35
VDET
VCC
AGND
VCAP
36
EN_CTRL
37
38
39
40
SOC_REST
SCL
SDA
VIN_LDO
41 (Exposed Pad) PGND
Copyright
©
2018 Richtek Technology Corporation. All rights reserved.
is a registered trademark of Richtek Technology Corporation.
DS5090C-00
September 2018
www.richtek.com
3