GSM100 USERS MANUAL
CHAPTER 5
APPENDIX
5.1Factory settings
The modem has the following factory settings. Please refer to the AT command document for the meaning of each
setting.
Related AT commands
AT+IPR
Factory Settings
9600
Description
DTE-DCE data rate
AT+IFC
AT+ICF
ATE
2,2
3,4
1
DTE-DCE flow control
DTE-DCE character framing
ECHO
AT&C
1
DCD signal
AT&D
1
DTR signal
ATQ
ATV
AT&S
0
1
1
Result code suppression
Response format
DSR signal
ATS0
0
Auto answer
AT+CLIP
AT+CRLP
AT+CSCS
AT+CMGF
AT+CSMP
AT+CNMI
0
Calling line ID presentation
Calling line ID restriction
“PCCP437”
1
1,67,0,0
0,0,0,0
Message format
Text mode parameters
New message indication
5.2Input / Output port
This port can be configured as either an input one or an output one.
To configure it as an input port, first issue AT+WIOW=2, 0 to disable the output port. Use AT+WIOR=3(Fargo
Maestro 100) or AT+WIOR=1(Fargo Maestro 20) to read the status of this input port. Response +WIOR: 0
represent Logic HIGH (>3V); Response +WIOR: 1 represent Logic LOW (<0.5V) To use it as an output port, issue
AT+WIOW=2,1 will turn it on and it will drain current to ground. The current is recommended not to exceed 10 mA.
Issue AT+WIOW=2,0 will turn it off.
5.3 RS232 AUTO-ONLINE mode (power saving)
When being in the AUTO-ONLINE, the RS232 transceiver will shutdown most of its hardware to save power if it
does not detect a valid input for more than 100uS. The RS232 transceiver will wake up when valid input is detected
again.
By default, the RS232 transceiver is put in AUTO-ONLINE. This mode can be turned off by issuing AT+WIOW=4,1.
DS020-7 Oct ‘06
©2006 REG No 277 4001, ENGLAND.
Page 15