GSM T
ELEMETRY
S
YSTEM
User Setup Commands cont..
PLEASE NOTE: ~ Denotes a ‘space’ in the format of a message
Command
Power Failure
number-to-text
(PNUM)
(Optional)
Description
This command is used to identify the mobile number
which is to be text if power has be removed from the 250.
PNUM can store up to 5 mobile numbers.
If either of INUMn or PNUM contain a mobile number that
is already present in the phone number list then this
number will be deleted. After deletion a text will be sent to
the user to confirm the deletion of that number.
This command sets an activation time of the relay outputs.
The default is to remain on following an ON command and
turn off following an OFF command.
If ‘t’ is set to a value from 1 to 9 then this sets the number
of seconds for which the output remains on after an ON
command. The OFF command is then ignored. If ‘t’ is set
to ‘0’, then the output returns to default setting
This command is used to control the responses that are to
be sent from the unit following receipt and carrying out of
a command.
Response on/off
(RESPONSE)
(Optional)
NOTE: messages which specifically demand a response
such as requests for input status will always be
responded to as will the UPW, UID and RESP~OFF
messages.
The default setting is for the response messages to be
turned of.
<UNIT PW>~RESPONSE~x
x=ON or OFF
Command:
Password38~RESPONSE~ON
Response:
Identity7~RESPONSE~ON~OK
Command Syntax
<UNIT PW>~PNUMn~
<number to text>
Where n=1 for power fail
Example
Command:
Password38~PNUM1~0033612345678
Command:
Password38~PNUM1~0033612345678
Response:
UID~PNUM1~<0033612345678>~deleted
250
Deleting numbers-to-
text
<UNIT PW>~x~<num to text>
Where x represents either
INUMn or PNUM1
Output delay time
(ODEL)
(Optional)
<UNIT PW>~O
DELn~t
n=Relay number
t=Delay time (seconds)
Command:
Password38~ODEL1~7
Response:
Identity7~ODEL1~7~OK
DS250-5 Nov ’06
©2006
REG No 277 4001, ENGLAND.
Page 6
RFSOLUTIONS [ RFSOLUTIONS.LTD ]
