Modular Radio Telemetry System
1.2
200 Series
Pre-Configure a 210Rx to operate with a 200/201 Tx series transmitter
Ensure option link J8 is open.
Apply power to the 210Rx, All output LEDS flash alternately. This is factory reset default state.
Apply power to any 200 or 201 Tx and briefly operate any input by shorting any of the input terminals on
the transmitter (ensure Enable link is fitted!), to force a transmit.
4. The 210Rx. LED2 flashes 5 times to indicate that the 210Rx is now configured for use with 200 / 201Tx.
5. Each time power is applied the 210Rx, LED2 flashes 5 times to show it is configured to operate with
200Tx transmitters.
6. Configuration is now complete and 200/201 transmitter unit(s) can be learned to the 210Rx receiver.
Note: Option links LK 1-16 have no affect on the operation of the remote telemetry system.
1.
2.
3.
1.3
1.
2.
3.
4.
5.
6.
7.
8.
Marry a 200/201 Tx to a 210Rx
On the 200/201 Tx, remove the Link header ‘OPT1‘ (auto Tx). (prevents automatic transmission during
the learn process).
On the 210Rx Ensure option link J8 is open.
Apply power to the 210Rx, note that LED2 flashes 5 times to show it is configured for use with 200Tx
transmitters.
Briefly press the 210Rx Learn Switch: Note that the 210Rx Learn LED (LED 17) will flash.
Wait until the 210Rx Learn LED has stopped flashing but is still illuminated.
Apply power to any 200/201 Tx and briefly operate any input by shorting any of the input terminals on the
Transmitter (ensure Enable link is fitted!), to force a transmit.
Note that the 210Rx learn LED will turn off.
The learn cycle is now complete and the transmitter/encoder will operate the systems.
1.4
1.
2.
3.
4.
Erasing the 210Rx Receiver Outputs (Return to Factory Default State)
To completely erase the 210Rx decoder’s memory, press and hold the 210Rx learn switch.
The learn LED will illuminate
Hold the learn switch until the learn LED extinguishes (approx 10 seconds).
Release the learn button and all the output LED’s will now flash alternately to indicate that all encoder data
has been erased and the 210Rx has returned to factory default state.
Note:
It is not possible erase individual transmitters.
DS200-11 March ’06
©2005 RF Solutions Ltd, www.rfsolutions.co.uk
Tel 01273 898000 Fax 01273 480661
Page 5
RFSOLUTIONS [ RFSOLUTIONS.LTD ]
