T
RAP
R
EMOTE
C
ONTROL
S
YSTEMS
(S
W
A
DDRESSING
)
Notes for use when Connecting the Remote Control System to a Clay Trap Release
This system is supplied complete with cable in order to connect to the Clay Trap Release.
Warning : Not all Clay Traps have the same wiring convention!
The system is pre-wired (as diagram below) to operate with most trap releases, before connecting, CHECK
YOUR CONNECTIONS. (using a voltmeter) if you are in any doubt, DO NOT CONNECT THE SYSTEM,
consult a qualified Electrician. Although the system operates on 12/24V damage may occur to the receiver unit
if wrong connections are made.
Installation Notes
1.
Connect Power to the Receiver unit.
The receiver unit requires the following connections to operate
12V supply (Brown wire as supplied)
OV Supply (Yell/GRN wire as supplied)
These may not match the wire colours on your Trap!
2. When the Receiver unit has power connected the Power LED will illuminate. This must be ‘on’ for the
system to operate.
3. Check operation of the Remote Control
4. When the power LED is ‘on’ the Remote Control System may be operated, Check operation by firing
the transmitter and check that;
•
The LED on the transmitter illuminates
•
The Rx Data LED on the Receiver unit (next to the power LED) illuminates.
If this does not work then check your Switch addresses on the transmitter and receiver.
5. Check the Wiring to the Trap
6. The receiver has been pre-wired to the following Circuit
117 Receiver
Unit
12V
Relay Output
COM
0V
N.C.
N.O.
Grn
/ Yell
Brown
Blue
0V
12V
Switched
Output
7. When operated, the receiver provides an output (Blue Wire) which momentarily connects to 0V.
8.
Alternative Wiring :
The switched output may be connected in several ways, please see the ‘Relay
Output Connections section. If in doubt consult a qualified electrician.
DS114-8 Oct ‘03
©2002 Reg. No. 227 4001, England
Page 3
RFSOLUTIONS [ RFSOLUTIONS.LTD ]
