RF2336
Pin
1
Function Description
Interface Schematic
Ground connection. Keep traces physically short and connect immedi-
GND
ately to ground plane for best performance.
Same as pin 1.
2
3
GND
RF IN
RF input pin. This pin is NOT internally DC blocked. A DC blocking
capacitor, suitable for the frequency of operation, should be used in
most applications. DC coupling of the input is not allowed, because this
will override the internal feedback loop and cause temperature instabil-
ity.
Same as pin 1.
4
5
GND
RF OUT
RF output and bias pin. Biasing is accomplished with an external series
resistor and choke inductor to V . The resistor is selected to set the
RF OUT
CC
DC current into this pin to a desired level. The resistor value is deter-
mined by the following equation:
4
RF IN
(VSUPPLY – VDEVICE
)
------------------------------------------------------
R =
ICC
Care should also be taken in the resistor selection to ensure that the
current into the part never exceeds 75mA over the planned oper-
ating temperature. This means that a resistor between the supply and
this pin is always required, even if a supply near 3.6V is available, to
provide DC feedback to prevent thermal runaway. Because DC is
present on this pin, a DC blocking capacitor, suitable for the frequency
of operation, should be used in most applications. The supply side of
the bias network should also be well bypassed.
Evaluation Board Schematic
(Download Bill of Materials from www.rfmd.com.)
VCC
P1-1
P1
1
P1-1
VCC
GND
NC
R1
22 Ω
C3
100 pF
C4
1 µF
2
3
L1
100 nH
50 Ω µstrip
J2
RF OUT
1
2
3
5
4
C2
100 pF
C1
100 pF
50 Ω µstrip
J1
RF IN
233X410-
Rev A3 001201
4-153
RFMD [ RF MICRO DEVICES ]
