SF2233E
• Low-loss RF SAW Filter
• Miniature 3 x 3 mm SMD Package
• Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-grounded Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Maximum Soldering Profile, 5 cycles/10 seconds maximum
1882.5 MHz
SAW Filter
Value
+12
3
-40 to +85
-40 to +85
265
Units
dBm
V
°C
°C
°C
SM3030-6
Electrical Characteristics
Characteristic
Center Frequency
Minimum Insertion Loss, 1850 to 1915 MHz
Amplitude Ripple, 1850 to 1915 MHz
Input/Output Return Loss, 1850 to 1915 MHz
Attenuation, Referenced to 0 dB:
800 to 1400 MHz
1480 to 1640 MHz
1930 to 1940 MHz
1940 to 1950 MHz
1972 to 2050 MHz
2110 to 2170 MHz
2300 to 2400 MHz
2400 to 3000 MHz
Source Impedance
Load Impedance
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 inch
Reel Size 13 inch
Z
S
Z
L
25
30
6
20
32
25
25
25
35
32
15
25
34
30
32
30
50
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
968, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Ω
Ω
dB
6.0
Sym
f
C
IL
MIN
Notes
Min
Typ
1882.5
1.2
2.0
6.5
Max
2.5
3.0
Units
MHz
dB
dB
P-P
dB
Electrical Connections
Connection
Input
Output
Case Ground
Terminals
2
5
All others
5 0 o h m
2
S A W
F ilte r
1 , 3 , 4 , 6
5
5 0 o h m
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
2.
3.
4.
5.
6.
7.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50
Ω
and measured with 50
Ω
network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: info@rfm.com
©2010 by RF Monolithics, Inc.
Page 1 of 5
SF2233E - 11/18/10
RFM [ RF MONOLITHICS, INC ]
