Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage
Storage Temperature
Operable Temperature Range
Soldering Temperature (10 seconds / 5 cycles maximum)
Value
10
12
-40 to +125
-40 to +125
260
Units
dBm
VDC
°C
°C
°C
Electrical Characteristics, -40°C to +125°C Per Note 3 Below
Characteristic
Center Frequency at 25°C
Insertion Loss
Passband Ripple Relative to IL
MIN
,Fc ±200 kHz
3 dB Bandwidth
Rejection Relative to IL
MIN
10 - 295 MHz
295 - 305 MHz
305 - 310 MHz
310 - 313 MHz
313 - 314 MHz
316 - 320 MHz
320 - 325 MHz
325 - 335 MHz
335 - 600 MHz
600 - 1000 MHz
Temperature
Frequency Aging
Impedance @ fc
Freq. Temp. Coefficient
Absolute Value during the First Year
Input Z
IN
= R
IN
llC
IN
Output Z
OUT
= R
OUT
llC
OUT
FTC
lfAl
Z
IN
Z
OUT
5
1
1, 3
BW
3
Sym
f
c
IL
MIN
Notes
1, 2, 3
1, 3
1, 3
1, 3
Minimum
314.85
Typical
315.00
2.3
0.5
Maximum
315.15
3.0
1.4
800
Units
MHz
dB
dB
kHz
500
44
39
27
17
7
9
16
32
42
55
600
49
44
30
20
10
12
20
36
45
60
0.032
≤10
1.92 kΩ || 5.93 pF
1.28 kΩ || 6.09 pF
dB
ppm/°C
2
ppm/yr
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all measurements are made with the filter installed in the specified test fixture which is connected to a 50
Ω
test system with
VSWR
≤
1.2:1. The test fixture L and C are adjusted for minimum insertion loss at the filter center frequency, f
c
. Note that insertion loss and band-
width and passband shape are dependent on the impedance matching component values and quality.
The frequency f
c
is defined as the midpoint between the 3 dB frequencies.
Where noted specifications apply over the entire specified operating temperature range of -40 °C to +125 °C.
The turnover temperature, T
O
, is the temperature of maximum (or turnover) frequency, f
o
. The nominal frequency at any case temperature, T
c
, may
be calculated from: f = f
o
[1 - FTC (T
o
- T
c
)
2
].
Frequency aging is the change in fc with time and is specified at +65 °C or less. Aging may exceed the specification for prolonged temperatures
above +65 °C. Typically, aging is greatest the first year after manufacture, decreasing significantly in subsequent years.
The design, manufacturing process, and specifications of this device are subject to change.
One or more of the following U.S. Patents apply: 4,54,488, 4,616,197, and others pending.
All equipment designs utilizing this product must be approved by the appropriate government agency prior to manufacture or sale.
2.
3.
4.
5.
6.
7.
8.
www.RFM.com E-mail: info@rfm.com
©2009 by RF Monolithics, Inc.
Page 2 of 5
RF3417D - 3/19/09
RFM [ RF MONOLITHICS, INC ]
