CL0902-L / CL1502-L
CL1802-L / CL2102-L
Low Noise Amplifier
Product Features
Applications
• GaAs p-HEMT chip on board
• No matching circuit needed
• High Maximum input power(+25dBm)
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• WiMAX, Wibro, WLAN
• RF Sub-Systems
• Small Size, High Heatsink
• Alumina Substrate
Package : CP-16A
• Pb Free / RoHS Standard
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. CL series are focused on giving lowest noise possible. The structure of the device is built with GaAs p-HEMT die
attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application notes all
together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are possible to have
custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
CL0902-L
CL1502-L CL1802-L CL2102-L
Parameter
Frequency Range
Units
MHz
dB
824~894
(Cellular)
890~960
(GSM)
1400~1600 1700~2000 1850~2200
21
20
±0.5
-17
-8.5
20
17
±0.5
-17
-10
21
16
±0.5
-18
-10
21
15
±1.0
-18
-10
20
Small Signal Gain (S21)
Gain Flatness
±0.5
-17
-8.5
20
dB
Input Return Loss (S11)
Output Return Loss (S22)
1dB Compression Point (P1dB)
dB
dB
dBm
dBm
dB
Output 3rd Order Intercept Point
(OIP3) (TYP.)
31
31
33
33
33
0.7
100
0.7
100
0.6
90
0.6
100
0.6
100
Noise Figure (TYP.)
DC Supply Current (Vdc=+5V)
mA
Test Condition
① Supply voltage = +5V, 50ohm System, Ta = 25℃
② OIP3 is measured with two tones, at an output power of +0dBm/tone separated by 1MHz.
▪ Tel : 82-31-250-5011
▪ rfsales@rfhic.com
page 1/5
▪ All specifications may change without notice.
▪ Version 6.2
RFHIC [ RFHIC ]
