R8C/13 Group
12.4 Timer (Timer C)
12.4.2 Output Compare Mode
In this mode, an interrupt request is generated when the value of TC register matches the value of
TM0 or TM1 register. Table 12.14 shows specifications in output compare mode. Figure 12.34 shows
an operation example of output compare mode.
Table 12.14 Output Compare Mode Specifications
Item
Count source
Count operation
Specification
f1, f8, f32, fRING-fast
• Count up
• Value in TC register is set to “000016” when a counting stops
TCC00 bit in TCC0 register is set to “1” (count start)
Count start condition
Count stop condition
Waveform output start
condition
TCC00 bit in TCC0 register is set to “0” (count stop)
When “1” (CMP output enabled) is written to TCOUT0 to TCOUT5 bits.(2)
Waveform output stop
condition
When “0” (CMP output disabled) is written to TCOUT0 to TCOUT5 bits.
I
nterrupt request
• When a match occurs in compare circuit 0 [compare 0 interrupt]
• When a match occurs in compare circuit 1 [compare 1 interrupt]
generation timing
• When Time C overflows [Timer C interrupt]
______
_______
INT3/TCIN pin function
Programmable I/O port or INT3 interrupt input
P10 to P12 pins and P30 to Programmable I/O port or CMP output(2)
P32 pins function
Counter value reset timing When TCC00 bit in TCC0 register is set to “0” (count stop)
Read from timer(1)
• Value in compare register can be read out by reading TM0 register and TM1 register.
• Count value can be read out by reading TC register.
Write to timer(1)
• Write to TC register is disabled.
• Values written to TM0 register and TM1 register are stored in compare register at the
following timings:
- When TM0 and TM1 registers are written if TCC00 bit is “0” (count stop)
- When counter overflows if TCC00 bit is “1” (in counting) and TCC12 bit in TCC1
register is “0” (free-run)
- When compare 1 matches counter if TCC00 bit is “1” and TCC12 bit is “1” (set TC
register to “000016” at compare 1 match)
Select function
• Timer C counter reload select function
Counter value in TC register at match occurrence in compare circuit 1 is set or not set
to “000016” selected by TCC12 bit in TCC1 register.
• Output level at match occurrence in compare circuit 0 can be selected by TCC15 to
TCC14 bits in TCC1 register. Similarly, output level at match occurrence in compare
circuit 1 can be selected by TCC17 to TCC16 bits in TCC1 register.
• Whether output is reversed or not can be selected by TCOUT1 to TCOUT0 bits in
TCOUT register.
NOTES:
1. TC, TM0, and TM1 registers should be accessed in 16-bit units.
2. When the corresponding port data is “1”, the waveform is output depending on the setting of the registers TCC1 and
TCOUT. When the corresponding port data is “0”, the fixed level is output (refer to Figure 12.30 CMP Waveform
Output Unit.
Rev.1.20 Jan 27, 2006 page 107 of 205
REJ09B0111-0120
RENESAS [ RENESAS TECHNOLOGY CORP ]
