THREE-PHASE WAVEFORM MODE
10.3 Three-phase mode 0
Continued from the preceding page.
Internal output for stabilization of output level
b7
b0
Count start register 0
(address 4016
1 1 1 1
)
Starts counting in timer A0.
Starts counting in timer A1.
Starts counting in timer A2.
Starts counting in timer A3.
Check whether the timer Ai interrupt request bit is “1” or not.
(Note that the first one-shot pulse width of timer Ai must be
the maximum among those of timers A0 through A2.)
Waiting for the dead time, which
was previously set, to elapse
➀ The output level is stabilized.
Three-phase waveform output is enabled.
b7
b0
Waveform output mode register
(address A616
1
)
Three-phase waveform output
is enabled.
Three-phase waveform output starts.
Fig. 10.3.2 Initial setting example for registers relevant to three-phase mode 0 (2)
7906 Group User’s Manual Rev.2.0
10-19
RENESAS [ RENESAS TECHNOLOGY CORP ]
