M16C/26 Group
5. Electrical Characteristics (VCC=5V)
5.5 Low Voltage Detection Circuit Electrical Charactristics
Table 16.7. Low Voltage Detection Circuit Electrical Characteristics (Note 1, Note 4
)
Standard
Typ.
Symbol
Measuring condition
Parameter
Unit
Min.
3.3
Max.
4.4
Voltage down detection voltage (Note 1)
Reset level detection voltage (Notes 1, 2)
Vdet4
Vdet3
3.8
V
V
2.2
2.8
3.6
VCC1=0.8 to 5.5V
V
V
Low voltage reset retention voltage
0.8
2.2
Vdet3s
Vdet3r
2.9
4.0
Low voltage reset release voltage (Note 3)
Note 1: Vdet4 > Vdet3
Note 2: Where reset level detection voltage is less than 2.7 V, if the supply power voltage is greater than the reset level detection voltage, the
operation at f(BCLK) ≤ 10MHz is guaranteed.
Note 3: Vdet3r > Vdet3 is not guaranteed.
Note 4: The low voltage detection circuit is designed to use when VCC is set to 5V.
Table 16.8. Power Supply Circuit Timing Characteristics
Standard
Typ.
Symbol
Measuring condition
Parameter
Unit
ms
Min.
Max.
2
td(P-R)
td(R-S)
td(W-S)
td(M-L)
td(S-R)
td(E-A)
Time for internal power supply stabilization during powering-on
STOP release time
150
150
50
µs
µs
µs
ms
µs
VCC1=2.7 to 5.5V
Low power dissipation mode wait mode release time
Time for internal power supply stabilization when main clock oscillation starts
Hardware reset 2 release wait time
VCC1=Vdet3r to 5.5V
VCC1=2.7 to 5.5V
6 (Note)
20
Low voltage detection circuit operation start time
20
Note : When VCC = 5V
Vdet3r
VCC
td(S-R)
Interrupt for
stop mode
release
CPU clock
td(R-S)
Rev.1.00 2004.6.10 page 22 of 37
REJ09B0176-0100Z