MIL-M-38510/110C
TABLE I. Electrical performance characteristics – Continued.
Conditions
-55°C ≤ T ≤ +125°C
Group A
subgroups
Device
type
Limits
Max
Unit
A
Test
Symbol
CS
see figure 2
unless otherwise specified
Min
80
Channel separation
7
01,02,
03,04,
05,06,
07,08
dB
T = +25°C,
A
see figure 7
1/ Device types 01 to 04 shall be tested at V
= 0 V, +15 V, and –15 V with ±V
CC
= ±20 V; and at V
= 0 V with
CM
CM
±V
CC
= ±5 V. Device types 05 and 06 should be tested at V
= –13 V with V
= 2 V and -V
CC
= -28 V;
CM
CC
V
= +15 V with +V
= 30 V and -V
= 0 V; V
CM
= +1.4 V with V
= 5 V and -V
= 0 V;
CM
CM
CC
CC
CC
CC
V
= –1.1 V at ±V
CC
= 2.5 V.
2/ CMR is determined by measuring input offset voltage as follows:
Offset voltage
condition
Device types
Units
01 - 04
05 and 06
+V
CC
35
5
-V
V
15
-15
+V
CC
30
2
-V
CC
0
-28
V
O
15
-13
CC
-5
-35
O
1
2
V
V
3/ Continuous limits will be considerably lower and apply for –55°C ≤ T ≤ 25°C.
A
4/ I
5/ I
and I
limits for device type 01 only at T = -55°C are –75 mA and 75 mA respectively.
SO(-) A
SO(+)
limits are the total for all four amplifiers at no load, connected as grounded followers.
CC
6/ AVS(+) for device types 05 and 06 only.
7/ Device types 05 and 06 transient response is specified with the input pulse referenced to 5 V. For application
purposes the device may be operated with the input referenced to ground, however, saturation effects will cause
the response time to increase by approximately 50 percent.
13
RAYTHEON [ RAYTHEON COMPANY ]
