FM24V01 - 128Kb I2C FRAM
Overview
The FM24V01 is a serial F-RAM memory device.
The memory array is logically organized as a 16,384
x 8 bit memory array and is accessed using an
industry standard two-wire (I
2
C) interface. Functional
operation of the F-RAM is similar to serial
EEPROM. The major difference between the
FM24V01 and serial EEPROM is F-RAM’s superior
write performance.
Two-wire Interface
The FM24V01 employs a bi-directional two-wire bus
protocol using few pins or board space. Figure 2
illustrates a typical system configuration using the
FM24V01 in a microcontroller-based system. The
industry standard two-wire bus is familiar to many
users but is described in this section.
By convention, any device that is sending data onto
the bus is the transmitter while the target device for
this data is the receiver. The device that is controlling
the bus is the master. The master is responsible for
generating the clock signal for all operations. Any
device on the bus that is being controlled is a slave.
The FM24V01 always is a slave device.
The bus protocol is controlled by transition states in
the SDA and SCL signals. There are four conditions
including start, stop, data bit, or acknowledge. Figure
3 illustrates the signal conditions that specify the four
states. Detailed timing diagrams are shown in the
electrical specifications section.
VDD
Memory Architecture
When accessing the FM24V01, the user addresses
16,384 locations each with 8 data bits. These data bits
are shifted serially. The 16,384 addresses are
accessed using the two-wire protocol, which includes
a slave address (to distinguish other non-memory
devices) and a 2-byte address. All 14 address bits are
used by the decoder for accessing the memory.
The access time for memory operation is essentially
zero beyond the time needed for the serial protocol.
That is, the memory is read or written at the speed of
the two-wire bus. Unlike an EEPROM, it is not
necessary to poll the device for a ready condition
since writes occur at bus speed. That is, by the time a
new bus transaction can be shifted into the part, a
write operation will be complete. This is explained in
more detail in the interface section below.
Users expect several obvious system benefits from
the FM24V01 due to its fast write cycle and high
endurance as compared with EEPROM. However
there are less obvious benefits as well. For example
in a high noise environment, the fast-write operation
is less susceptible to corruption than an EEPROM
since it is completed quickly. By contrast, an
EEPROM requiring milliseconds to write is
vulnerable to noise during much of the cycle.
Note that it is the user’s responsibility to ensure that
V
DD
is within datasheet tolerances to prevent
incorrect operation.
Microcontroller
R
min
= 1.1 K
ohm
R
max
= t
R/Cbus
SDA
SCL
SDA
SCL
FM24V01
A0
A1
A2
FM24V01
A0
A1
A2
Figure 2. Typical System Configuration
Rev. 1.1
Sept. 2011
Page 3 of 14