QN8006B/8006LB
SYMBOL
PARAMETERS
CONDITIONS
MIN
TYP
MAX UNIT
Notes:
1. FORCE_MO=0;
Table 8: Timing Characteristics
(Vcc = 2.7 ~ 5.0 V, TA = -25 ~ 85 oC, unless otherwise noticed. Typical values are at Vcc = 3.3V and TA = 25oC).
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNIT
From rising edge of CEN to
PLL settled and transmitter
ready for transmission.
Chip power-up time 1
0.6
Sec
τpup
TMOUT [1:0] = 00
TMOUT [1:0] = 01
TMOUT [1:0] = 10
TMOUT [1:0] = 11
1
3
5
Auto Standby time 2
Min
Sec
τastby
Never
Channel switching
time1
From any channel to any
channel.
0.1
τchsw
Transmitter Timing
Wake-up time from
25
5
200
msec
msec
τwkup
standby to transmit
Clear channel scan time Per channel.
Receiver Timing
τCCS
Wake-up time from
standby to receive
Standby to RX mode.
RX mode to TX mode.
200
500
msec
µsec
τwkup
Mode switch time from
receive to/from
transmit
τtrx
TX mode to RX mode.
Per channel, including Seek 1, 3
.
100
5
msec
msec
Tune time
τtune
Notes:
1. Guaranteed by design.
2. Chip automatically goes from IDLE to standby mode; TMOUT = 11 equivalent to auto standby disabled.
3. More time is required until audio is output.
Rev 2.08 (04/10)
Copyright ©2010 by Quintic Corporation
Page 11
Confidential A
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).