April 2008
rev 1.5
ASM161/ASM162
Valid Reset with VCC under 1.1V
Application Information
To ensure that logic inputs connected to the ASM162
RESET pin are in a known state when VCC is under 1.1V,
a 100kΩ pull-down resistor at RESET is needed. The
Glitch Resistance
The ASM161/162 are relatively immune to short duration
negative-going VCC transients/glitches. A VCC transient
that goes 100mV below the reset threshold and lasts 20s
or less will not typically cause a reset pulse.
value is not critical.
This scheme does not work with the open-drain outputs
of ASM161.
Absolute Maximum Ratings
Parameter
Min
Max
Unit
Pin Terminal Voltage with Respect to Ground
VCC
-0.3
-0.3
6.0
V
RESET, RESET and MR
Input Current at VCC and MR
Rate of Rise at VCC
VCC + 0.3
20
V
mA
V/µs
mW
°C
100
Power Dissipation (TA = 70°C)
Operating Temperature Range
Storage Temperature Range
320
-40
-65
85
160
°C
Lead Temperature (soldering, 10 sec)
ESD rating
300
°C
HBM
MM
2
200
KV
V
Note: These are stress ratings only and functional operation is not implied. Exposure to absolute maximum ratings for prolonged time periods may
affect device reliability.
µP Supervisory Circuit
4 of 9
Notice: The information in this document is subject to change without notice.