LYT0002/0004-0006
Conditions
SOURCE = 0 V; TJ = -40 to 125 °C
See Figure 8
Parameter
Symbol
Min
Typ
Max
Units
(Unless Otherwise Specified)
Output
TJ = 25 °C
42
67
21
40
11
19
6
55.2
88.4
27.6
44.2
13.8
22.1
8.1
LYT0002
ID = 13 mA
TJ = 100 °C
TJ = 25 °C
TJ = 100 °C
TJ = 25 °C
TJ = 100 °C
TJ = 25 °C
TJ = 100 °C
LYT0004
ID = 25 mA
ON-State
Resistance
RDS(ON)
W
LYT0005
ID = 35 mA
LYT0006
ID = 45 mA
11
12.9
50
LYT0002
LYT0004
LYT0005
LYT0006
VBP = 6.2 V,
VFB ≥2 V,
VDS = 560 V,
TJ = 25 °C
60
OFF-State Drain
Leakage Current
IDSS
mA
75
90
VBP = 6.2 V, VFB ≥2 V,
Breakdown Voltage
BVDSS
700
50
V
TJ = 25 °C
tR
tF
Rise Time
50
50
ns
ns
V
Measured in a Typical Buck
Converter Application
Fall Time
DRAIN Supply Voltage
Output Enable Delay
tEN
See Figure 10
10
ms
Output Disable
Setup Time
tDST
0.5
ms
ms
%
Not Applicable
LYT0002
Auto-Restart
ON-Time
TJ = 25 °C
See Note H
tAR
LYT0004-0006
50
Not Applicable
LYT0002
Auto-Restart
Duty Cycle
DCAR
LYT0004-0006
6
NOTES:
A. Total current consumption is the sum of IS1 and IDSS when FEEDBACK pin voltage is ≥2 V (MOSFET not switching) and the sum of
IS2 and IDSS when FEEDBACK pin is shorted to SOURCE (MOSFET switching).
B
Since the output power MOSFET is switching, it is difficult to isolate the switching current from the supply current at the DRAIN.
An alternative is to measure the BYPASS pin current at 6 V.
C. See Typical Performance Characteristics section Figure 15 for BYPASS pin start-up charging waveform.
D. This current is only intended to supply an optional optocoupler connected between the BYPASS and FEEDBACK pins and not
any other external circuitry.
E. For current limit at other di/dt values, refer to Figure 14.
F. This parameter is guaranteed by design.
G. This parameter is derived from characterization.
H. Auto-restart on time has the same temperature characteristics as the oscillator (inversely proportional to frequency).
11
www.powerint.com
Rev. A 06/13