ZM7300G Series Digital Power Manager
Data Sheet
specific bit in the POL Programming Status registers will be set. The DPM considers the POL converter
to be programmed, and continues programming the next POL converter.
Upon completion of the programming, the DPM will turn-on the POL converters, if the Auto Turn-On is
enabled in the POL Group configuration window shown in Figure 10. Otherwise, the user will need to
send the turn-on command via the I2C bus.
Figure 10. POL Group Configuration Window
10.3.2 Programming Time
Total system programming time can be determined from the following equation:
TPROGR TINIT nPOL TPOL nAD TAD
ZD-00896 Rev. 5.1, 13-Jul-10
www.power-one.com
Page 15 of 33
POWER-ONE [ POWER-ONE ]
