FNP1500/1800 Front-Ends
& FNR-3 Power Shelf Data Sheet
Fulcrum:
The handle has been designed to allow easy plug-in and -out in a rack system. The handle (lever) fits into a counter piece
(fulcrum) which is fixed to the bottom of the rack. During the plug, the fulcrum holds the unit down and guides it towards the
output connector. The Power-One part number of the fulcrum and its associated mounting accessories is: HZZ01223.
Individual fulcrum sets can be also ordered: Power-One part no.: HZZ01223.
Note: Each HZZ01223 set contain 2 fulcrums, 2 supports, and mounting accessories.
I2C to USB Interface HZZ02002G:
I2C <to>USB
Interface
I2C Management Software: All FNP front-ends can be controlled via Power-One's GUI-driven I2C Management
software and an I2C-to-USB interface (P/N HZZ02002G). An I2C Programming Manual describes the complete
range of parameters that can be programmed to the FNP1500/1800 front-ends. This manual is available by
searching on "FNP1500" at www.power-one.com.
NUCLEAR AND MEDICAL APPLICATIONS - Power-One products are not designed, intended for use in, or authorized for use as critical
components in life support systems, equipment used in hazardous environments, or nuclear control systems without the express written consent
of the respective divisional president of Power-One, Inc.
TECHNICAL REVISIONS - The appearance of products, including safety agency certifications pictured on labels, may change depending on the
date manufactured. Specifications are subject to change without notice.
MCD10074 Rev. 1.2, 15-Apr-10
Page 17 of 17
www.power-one.com
POWER-ONE [ POWER-ONE ]
