DGP30 SERIES – SINGLE OUTPUT
NOTES
(1) All parameters measured at Tc=25 °C case temperature, nominal input voltage and full rated load
unless otherwise noted. Refer to the Technical Reference Section for definition of terms,
measurement circuits and other information.
(2) Minimum load required for rated regulation only. Module will not be damaged if run at less than
minimum load.
(3)
Short term stability is specified after a 30 minute warm-up at full load, and with constant line, load
and ambient conditions.
(4) The input ripple rejection is specified for DC to 120Hz ripple with a modulation amplitude of 1% Vin.
For the Most Up-To-Date Information
www.power-one.com
24 Hours/Day—7 Days/Week
(5) Noise is measured per Technical Reference Section. Output noise is measured with a 1µF tantalum
capacitor connected 1” from the output pins.
NUCLEAR AND MEDICAL APPLICATIONS Power-One products are not authorized for use as critical components in life support systems, equipment used in hazardous environments,
or nuclear control systems without the express written consent of the President of Power-One, Inc.
TECHNICAL REVISIONS The appearance of products, including safety agency certifications pictured on labels, may change depending on the date manufactured. Specifications are
subject to change without notice.
2
POWER-ONE [ POWER-ONE ]
