PM7340 S/UNI-IMA-8
PRELIMINARY
INVERSE MULTIPLEXING OVER ATM
DATA SHEET
PMC-2001723
ISSUE 3
INVERSE MULTIPLEXING OVER ATM
Restart_group
Restart the specified group. When executed,
the GSM goes back to “start-up” state and all tx
links return to the “unusable” state and the Rx
links return to the “unusable” state but report
“Not in Group” since the LID is not yet
validated. This command is intended to enable
the change of parameters during the group
start-up phase and to provide a local group
reset for other conditions.
Inhibit_group
Set the internal group inhibiting status flag.
Once a group is considered inhibited, it will go
to BLOCKED state instead of the
OPERATIONAL state when sufficient links exist
in the group.
If the group is already in OPERATIONAL state
when the command is issued, the GSM will go
to BLOCKED state, and thus block the TX data
path. However, the RX data path remains on.
Not_inhibit_group
Start_LASR
Clear the internal group inhibiting status. If the
group is currently in BLOCKED state, the GSM
will go to OPERATIONAL state.
Start LASR procedure on one or more links.
The links involved may either be new links or
existing links with a failure/fault/inhibiting
condition. If the group configuration is
symmetric, links should be added in both the
TX and RX direction.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
71
PMC [ PMC-SIERRA, INC ]
